Firstly check that you re using it within the range required for your opener.
My craftsman garage door opener light stays on.
This feature is triggered when you interrupt the signal between the photo eye sensors when entering or exiting the open garage door.
You will use it as a jumper wire in the next step.
Here are a few reasons why your blue max lift master or other garage door opener light stays on longer than the usual time.
You may also need to reprogram your keypad or replace the batteries in it.
Most openers come with motion sensors.
If you re too far away this can cause a problem with opening or closing the door.
The light feature was designed to turn on automatically so you never have to enter a dark garage.
This is a feature that is exclusive to chamberlain group openers.
Adjusting the light timer on a newer digital unit.
Faulty wiring is the most likely cause of a problem with the light.
The range on most light units is from 90 to 240 seconds.
Cut a 3 inch strand of insulated wire and peel the ends.
The light will come on any time someone walks in front of the beams.
This feature comes on when the sensor detects movement.
Chamberlain group products which include the liftmaster chamberlain sears craftsman line of garage door openers have a feature where the opener light will turn on if you cross the safety sensor beam shooting across the opening of your garage door.
Check your installation manual for exact wiring instructions.
A clockwise turn will increase the time the light stays on while a counter clockwise turn will decrease the time.
The opener s light may be staying on because the light feature has been activated.
Why the light stays on.
Also verify the antenna on the motor unit is in the proper placement.
Make sure the power is properly connected and that no wires have worked loose.
Check the wiring elsewhere on the garage door opener.
Insert the jumper wire into the wall control terminals on the garage door opener to see if the garage door moves.